Pneumatic-hydraulic rivet tool with intake - ProSet XT2

ProSet XT1 – pneumatic-hydraulic rivet gun with vacuum pick-up

ProSet XT1 is a pneumatic-hydraulic blind riveting tool designed for fast, repeatable and controlled riveting in production, installation and service environments. By combining pneumatic power with a hydraulic intensifier, it delivers stable pulling performance while keeping the tool compact and practical for everyday use. The integrated vacuum pick-up helps hold the rivet on the nosepiece during positioning, which speeds up work and reduces handling errors—especially in overhead or one-handed applications.

Rivet range and applications

The tool is intended for standard blind rivets and sealed (closed-end) rivets within the following limits:

• Ø 2.4–3.2 mm – standard blind rivets and sealed rivets in all materials
• Ø 4.0 mm – standard blind rivets and sealed rivets in Al/Al, Al/Steel, Cu/Steel combinations

This covers typical use in vehicle body building, sheet metal and profile assemblies, enclosure and panel mounting, maintenance work, and general industrial fastening where speed and consistent joint quality are required.

Technical data

• Working pressure: 5.5–7 bar
• Pulling force: 6.5 kN at 6 bar
• Stroke: 18 mm
• Air consumption: 1.5 l
• Noise level: 77.95 dB
• Weight: 1.17 kg

Why XT1 performs well in real production

Consistent pull for repeatable joints

The pneumatic-hydraulic principle provides a stable, controlled pull when the correct air pressure is maintained. This helps achieve consistent rivet setting and reduces issues such as incomplete setting or irregular mandrel breaks—both of which cost time and create quality risk.

Vacuum pick-up = faster positioning

Vacuum pick-up is not a gimmick. In series work it saves time on every cycle and helps when access is limited. It supports quicker rivet placement, more reliable alignment to the hole, and fewer drops—especially with smaller diameters.

Lower fatigue in daily use

At 1.17 kg, the tool is balanced for extended use. In practice, weight and ergonomics directly influence output when hundreds of rivets are set per shift—particularly in awkward positions on vehicle bodies or large assemblies.

Correct nosepieces and collets (by rivet diameter)

For correct setting performance and long tool life, use the correct nosepiece and collet according to rivet diameter:

• For Ø 2.4 mm rivets: nosepiece 2851224.163 / collets 2851100.163
• For Ø 3.0–3.2 mm rivets: nosepiece 2851230.163 / collets 2851100.163
• For Ø 4.0 mm rivets: nosepiece 2851240.163 / collets 2851100.163

Practical benefit: the collets are the same across the listed diameters; only the nosepiece changes. That simplifies spares management and reduces changeover time.

Best-practice notes for trouble-free operation

• Maintain a stable air supply within 5.5–7 bar and use proper air filtration/regulation.
• Always match the nosepiece to the rivet diameter to reduce wear and avoid mis-setting.
• For sealed rivets, ensure correct hole preparation and proper seating before setting.

Product category

ProSet XT1 belongs to the pneumatic-hydraulic riveting tools range. It is a solid choice for operations that rivet regularly and require speed, repeatable joint quality, and straightforward setup for common rivet diameters from 2.4 to 4.0 mm.